TCHD High Temp. PSU Plastic Injection Mold

PSU (polysulfone) is a high temperature, amber colored, semi-transparent plastic material with good mechanical properties.Polysulfone is resistant to degradation from hot water and steam and it is often used in medical and food preparation applications where repeated sterilization is required. FDA compliant grades available.
Send Inquiry
Description

This PSU plastic injection mold is built for parts that must stay transparent and stay strong in hot water, steam or repeated sterilisation. PSU runs at melt temperatures well above polycarbonate, so the tool, the hot runner and the drying routine are specified around a material that punishes shortcuts.

semi-transparent PSU high temperature plastic part

PSU performance characteristics

  1. Semi-transparent plastic: light passes through, so internal flow marks and gate blush are visible.
  2. Resists hydrolysis when exposed to hot water or steam.
  3. Strong and stiff at room temperature and above it.
  4. Can be used at higher temperatures than acrylic or polycarbonate.
  5. Thermoformable after moulding.

What the PSU plastic injection mold must handle

  • Melt temperature — PSU is processed roughly in the 330–400 °C band, so heater bands, thermocouples and hot-runner zones have to be rated above that, not at PC settings.
  • Drying — the resin absorbs moisture and must be dried before every run; a desiccant dryer, not an oven, is the practical choice.
  • Steel and gate — a heated gate and a generous sprue reduce frozen-in stress in a semi-transparent part, and cavity steel is chosen for polishability because a visible part shows every tool mark.
  • Venting and ejection — PSU is stiff at ejection temperature, so ejector area and vent depth are checked at design review rather than at trial.
  • Mould temperature control — a hot-oil unit keeps the cavity above 120 °C, which reduces the internal stress that later shows as crazing in a steam cycle.

Where PSU parts are used

Medical trays and sterilisation housings, baby bottles and drinking vessels, food-service lids, transparent pump bodies and electrical components that see heat. In each case the reason for choosing PSU over polycarbonate is the same: the part is expected to survive repeated contact with hot water or steam without turning cloudy or cracking.

high temp PSU plastic injection mold core and cavity

PSU moulded transparent housing and components

Related pages

Quick-change and high-temperature tooling is described on the MUD U frame page. Process settings are covered in the injection molding design review.

Contact

For PSU and PPSU parts, send the drawing, the wall thickness and the sterilisation cycle. jack — +86 13603037469 — jack@runtooprecision.com.